輕質混凝土板材檢測

輕質混凝土板材檢測項目報價？??解決方案？??檢測周期？??樣品要求？

點 擊 解 答??

GB/T 31543-2015單層卷材屋面系統抗風揭試驗方法

本標準規定了模擬抗風揭拉拔測試方法、靜態正壓或負壓抗風揭測試方法和動態負壓抗風揭測試方法三種測試單層卷材屋面系統抗風揭性能的試驗方法。本標準適用于采用機械固定或滿粘施工的單層卷材屋面系統。

GB/T 34327-2017建筑幕墻術語

本標準規定了建筑幕墻的通用術語和定義。本標準適用于各種類型的建筑幕墻。

GB/T 37260.1-2018箱型輕鋼結構房屋 第1部分:可拆裝式

GB/T 37260的本部分規定了可拆裝式箱型輕鋼結構房屋的術語和定義、規格和標記、一般要求、材料及構件、工藝及性能、試驗方法、檢驗規則以及標志、包裝、運輸和貯存。本部分適用于具有建筑使用功能，可獨立使用的或作為一個建筑體組合模塊的可拆裝式箱型輕鋼結構房屋。

CJJ 122-2017游泳池給水排水工程技術規程

本規程適用于新建、擴建、改建的游泳池及類似水環境水池的給水排水工程的設計、施工、檢測、調試、驗收、運行、維護和管理。

JC/T 2122-2012輕質混凝土吸聲板

本標準規定了輕質混凝土吸聲板的術語和定義、分類、規格尺寸和標記、一般規定、技術要求、試驗方法、檢驗規則以及標志、包裝、運輸和貯存等。本標準適用于以水泥為膠凝材料，以輕集料為集料，加入水和外加劑，經攪拌、入模成型、養護制成的具有吸聲功能的制品，可用于建筑、公路、鐵路、市政等工程。

LY/T 2389-2014輕型木結構建筑覆面板用定向刨花板

本標準規定了輕型木結構建筑覆面板用定向刨花板的術語和定義、分類、要求、試驗方法、抽樣方法及判定規則、工廠質量控制、標識、包裝、運輸和貯存等。本標準適用于輕型木結構建筑覆面板用的定向刨花板，包括用作屋面板、墻面板和樓面板的定向刨花板。本標準涉及的定向刨花板其膠合等級為暴露I級。

JG/T 432-2014建筑結構保溫復合板

本標準規定了建筑結構保溫復合板的術語和定義、分類和標記、材料、要求、試驗方法、檢驗規則、標志及包裝、運輸與貯運等。本標準適用于建筑非承重圍護結構用保溫復合墻板。

JGJ 3-2010高層建筑混凝土結構技術規程

本規程適用于10層及10層以上或房屋高度大于28m的住宅建筑以及房屋高度大于24m的其他高層民用建筑混凝土結構。非抗震設計和抗震設防烈度為6至9度抗震設計的高層民用建筑結構，其適用的房屋大高度和結構類型應符合本規程的有關規定。本規程不適用于建造在危險地段以及發生震斷裂小避讓距離內的高層建筑結構。

JGJ 209-2010輕型鋼結構住宅技術規程

本規程適用于以輕型鋼框架為結構體系,并配套有滿足功能要求的輕質墻體、輕質樓板和輕質屋面建筑系統,層數不超過6層的非抗震設防以及抗震設防烈度為6~8度的輕型鋼結構住宅的設計、施工及驗收。

JGJ/T 229-2010民用建筑綠色設計規范

本標準適用于新建、改建和擴建民用建筑的綠色設計。

JGJ/T 275-2013密肋復合板結構技術規程

本規程適用于8層及8層以下且房屋高度不超過24m的多層密肋復合板結構及9層及9層以上或房屋高度超過24m的高層密肋復合板結構。非抗震設計和抗震設防烈度為6度至8度抗震設計的密肋復合板結構,其適用的房屋大高度應符合本規程的有關規定。本規程不適用于建造在危險地段以及發震斷裂小避讓距離內的密肋復合板結構。

JGJ 367-2015住宅室內裝飾裝修設計規范

本規范適用于住宅的室內裝飾裝修設計，不適用屬于歷史文物保護的住宅的室內裝飾裝修設計。

JGJ/T 398-2017裝配式住宅建筑設計標準

本標準適用于采用裝配式建筑結構體與建筑內裝體集成化建造的新建、改建和擴建住宅建筑設計。

ASTM C1153-2010用紅外線影象為屋面防潮定位的標準實施規程

This practice is used to outline the minimum necessary elements and conditions to obtain an accurate determination of the location of wet insulation in roofing systems using infrared imaging. This practice is not meant to be an instructional document or to provide all the knowledge and background necessary to provide an accurate analysis. For further information, see ANSI-ASHRAE Standard 101 and ISO/DP 6781.3E. This practice does not provide methods to determine the cause of moisture or its point of entry. It does not address the suitability of any particular system to function capably as waterproofing.1.1 This practice applies to techniques that employ infrared imaging at night to determine the location of wet insulation in roofing systems that have insulation above the deck in contact with the waterproofing. This practice includes ground-based and aerial inspections. (Warning8212;Extreme caution shall be taken when accessing or walking on roof surfaces and when operating aircraft at low altitudes, especially at night.) (Warning8212;It is a good safety practice for at least two people to be present on the roof surface at all times when ground-based inspections are being conducted.) 1.2 This practice addresses criteria for infrared equipment such as minimum resolvable temperature difference, spectral range, instantaneous field of view, and field of view. 1.3 This practice addresses meteorological conditions under which infrared inspections shall be performed. 1.4 This practice addresses the effect of roof construction, material differences, and roof conditions on infrared inspections. 1.5 This practice addresses operating procedures, operator qualifications, and operating practices. 1.6 This practice also addresses verification of infrared data using invasive test methods. 1.7 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.8 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in 1.1.

EN 1992-1-1-2004歐洲法規2.混凝土結構設計.第1-1部分:一般規則和建筑規則［代替:CEN ENV 1992-1-3,CEN ENV 1992-1-4,CEN ENV 1992-1-5,CEN ENV 1992-1-6］

P Eurocode 2 applies to the design of buildings and civil engineering works in plain, reinforced and prestressed concrete. It complies with the principles and requirements for the safety and serviceability of structures, the basis of their design and verification that are given in EN 1990: Basis of structural design.

EN 15287-1-2007煙囪.煙囪的設計,安裝和試用.第1部分:非密封房間加熱器具用煙囪［代替:CEN EN 12391-1］

This European Standard describes the method of specifying the design, installation criteria for system chimneys, construction of custom built chimneys, and the relining of existing chimneys. It also gives information on commissioning of chimneys.This European Standard also deals with connecting flue pipes.This European Standard does not apply to freestanding chimneys covered by EN 13084-1.This European Standard excludes chimneys designated H (high positive pressure chimneys) and chimneys for room-sealed heating appliances. For the purpose of this European Standard the term \"installation\" includes construction.

DIN 4102-4-2016建筑材料和建筑構件的耐火性能.概要和分級的建筑材料、構件和特種構件的應用

This document contains catagorized results of fire tests of buildings materials, components and construction types. Due to the assignment to the classes of building materials according to DIN 4102 part 1 and the fire resistance classes of the other parts of DIN 4102 respectively, further fire tests for the verification of usability required by the building regulations are not necessary.